Key takeaways
- Under the 2022 FDA Food Code, hot foods are held at 135°F or above and cold foods at 41°F or below[1].
- Time can replace temperature control for up to 4 hours, or up to 6 hours for cold food under stricter conditions, but only with written procedures[1].
- CDC found that one in seven restaurants stored food in refrigerators above 41°F[2].
- Your local code may differ: New York City, for example, requires hot holding at 140°F[3].
What the danger zone means in a restaurant
The temperature danger zone is the range in which bacteria in food can multiply quickly. Consumer guidance often rounds it to 40°F to 140°F. Restaurant rules are more precise, because inspectors need a line they can measure. The FDA Food Code, which most state and local codes are based on, sets the line for time/temperature control for safety food, usually called TCS food: hold it at 135°F or above, or at 41°F or below[1].
TCS food is food that needs temperature control to stay safe: cooked meats, poultry and fish, cooked rice and pasta, cooked vegetables, dairy, cut melons, cut tomatoes and cut leafy greens, sprouts, garlic-in-oil mixtures and most sauces made from these. Bread, dry goods and most uncut whole produce are not TCS. When in doubt, treat it as TCS and ask your health department.
The numbers that matter
Source: US Food and Drug Administration, 2022[1]
Show the data
| Control point | Temperature (°F) |
|---|---|
| Cold holding (max) | 41 °F |
| Untreated shell eggs, air (max) | 45 °F |
| Cooling checkpoint at 2 hours (max) | 70 °F |
| Qualifying roasts, hot holding (min) | 130 °F |
| Hot holding (min) | 135 °F |
| Situation | 2022 Food Code requirement | What to do on the line |
|---|---|---|
| Cold holding | 41°F or below | Set reach-ins and walk-ins to run colder than 41°F so that food stays below the line during busy service |
| Hot holding | 135°F or above | Check steam wells and holding cabinets with a probe in the food, not by the dial |
| Certain roasts | May be held at 130°F or above if cooked and held as the code specifies | Use only for whole roasts cooked to code; label them |
| Shell eggs not treated for Salmonella | Stored in equipment holding air at 45°F or below | Keep eggs in the walk-in, not on the line overnight |
| Cooling cooked food | 135°F to 70°F within 2 hours, then to 41°F within 6 hours total | Log the start time and both checkpoints |
| Time as a public health control | Up to 4 hours, or up to 6 hours for cold food kept at 70°F or below | Mark the discard time on every container |
These figures come from the 2022 Food Code[1]. FDA has since issued a 2026 edition[4], and each state adopts editions on its own schedule, so the version your inspector enforces may differ in places. The direction never changes: keep TCS food out of the middle range, and be able to prove it.
Where restaurants slip
Temperature failures are rarely dramatic. They happen in the gaps between checks. CDC research on cooling found that one in seven restaurants stored food in refrigerators above 41°F[2]. The usual causes are familiar to any kitchen manager:
- Reach-in doors opened constantly during service, so the unit never recovers.
- Line inserts overfilled above the cold rail, where the top layer sits in warm air.
- Steam wells switched on late, or filled with too little water to heat the pans evenly.
- Hot food left on the counter to cool before it goes in the walk-in.
- Thermometers that read wrong because nobody has checked them in months.
- Delivery cases left on the dock while the team finishes prep.
Each of these has an easy fix, and each fix is cheaper than the waste of throwing out a full rail of product after an inspector's probe reads 47°F.
Set up equipment so compliance is the easy option
Good habits fail when equipment works against them. A few setup choices remove most of the daily temperature fights before anyone has to think about them.
- Run cold units with a margin: if product must stay at 41°F or below, aim for the unit to hold product several degrees colder, so a busy door-open hour does not push it over.
- Fill line inserts only to the level the cold rail actually chills, and swap in a fresh, pre-chilled insert rather than topping up a warm one.
- Pre-heat steam wells with enough water before service, and load food into them already hot, not warm from the walk-in.
- Give every station its own probe thermometer, clipped in the same spot, with a sanitizer wipe beside it.
- Put a hanging thermometer in the warmest part of each walk-in, usually near the door, not at the back by the evaporator.
- Schedule deliveries for times when someone is free to put product away immediately.
Write the target settings for each unit on a label on the unit itself. When a reading drifts, the cook can see at a glance what normal looks like.
A daily routine by shift
Opening
Check and log every cold unit with a product probe, check that thermometers pass the ice-water test on the weekly schedule, and confirm overnight cooling logs are complete.
Before service
Confirm steam wells and holding cabinets are at temperature with food in them, and label any time-controlled items with their discard time.
During service
Check hot holding at least every two hours and cold rails mid-shift. Note corrective actions next to any bad reading.
Closing
Discard time-controlled food past its mark, start cooling logs for anything cooked late, and log final cold-unit readings.
Weekly
The manager reviews a week of logs for gaps, repeated near-misses and units that need service.
Using time instead of temperature
Sometimes temperature control is impractical: a sushi rice station, a brunch buffet, sandwiches made to order at a counter. The Food Code lets you use time as the control instead, which it calls time as a public health control. There are two versions, and both require written procedures kept on site and shown to the inspector on request[1].
| Rule | Up to 4 hours | Up to 6 hours (cold food only) |
|---|---|---|
| Starting temperature | 41°F or below from cold holding, or 135°F or above from hot holding | 41°F or below |
| Temperature during the period | No limit | Must not exceed 70°F; monitored or ambient kept to ensure it |
| Marking | Mark the time 4 hours after removal from temperature control | Mark both the removal time and the time 6 hours later |
| At the end | Cook and serve, serve if ready-to-eat, or discard | Discard if over 70°F; otherwise use or discard by 6 hours |
| Unmarked or overdue containers | Discard | Discard |
Choose the foods
List exactly which items will be held on time, such as cooked sushi rice or a buffet line, and which option applies.
Write the procedure
Describe how food is removed from temperature control, how containers are marked, who checks the clock and what happens at the deadline.
Mark every container
Use a label or marker with the discard time, not the start time alone. Staff should not have to do arithmetic at 1 p.m. on a Saturday.
Discard on time
Set a timer, and make discarding at the deadline part of a named person's job.
Never return it
Food held under time control cannot go back into refrigeration or hot holding to restart the clock.
Logs that prove control
A log is how you show an inspector, and yourself, that the rules were followed when nobody was watching. Keep it short, so it gets filled in.
- Cold holding: each unit, at opening, mid-shift and closing, with the food temperature from a probe in a product, not just the air dial.
- Hot holding: each well or cabinet, at least every two hours during service, with corrective action noted.
- Cooling: start time and temperature, the two-hour check and the final check. The method is covered in cooling food safely: the two-stage rule.
- Time control: item, removal time, discard time and initials of the person who discarded it.
- Thermometer checks: date, method and result for each thermometer.
Thermometers deserve their own line. The Food Code requires food thermometers scaled only in Fahrenheit to be accurate to within 2°F and to be calibrated as the manufacturer specifies[1]. An ice-water check at the start of each week takes a minute: a probe in a slurry of crushed ice and water should read 32°F.
Corrective actions your team should know
A log only works if staff know what to do when a reading is wrong. Write corrective actions next to each check, so the cook does not have to find a manager for routine fixes.
- Cold food reads above 41°F: check how long it has been out of range. If you cannot establish that, follow your written procedure or discard. Move remaining product to a working unit and call for service.
- Hot food reads below 135°F: reheat as your code allows if it was cooked and cooled properly, or discard if you cannot establish its history.
- Time-controlled food has no label: discard it. The code is explicit on this point[1].
- A thermometer fails its ice check: take it out of use and recalibrate or replace it, then recheck the last readings it took.
Write the corrective action in the log next to the bad reading. An inspector who sees a high reading followed by a correction sees a system working.
Local codes can differ
Do not assume the Food Code numbers apply everywhere. New York City's inspection scoring, for example, treats hot food not held at or above 140°F as a violation, and its cold-holding item also sets 38°F for smoked or processed fish[3]. In that city, a single hot-holding violation can score from 7 to 10 points, depending on how serious the condition is[3], so it is worth knowing your local number exactly.
Example: a fictional restaurant group opens its first New York location using the hot-holding settings from its other sites, which hold at 135°F. On the first inspection the steam table reads 137°F, compliant elsewhere but a violation in this city. The group resets every hot-holding target to 145°F so that normal swings stay above the local line.
For how these rules fit into inspections, see HACCP plans: when restaurants need one for specialized processes, and preventing allergen cross-contact in the kitchen for the other half of safe prep.
Frequently asked questions
What is the temperature danger zone for restaurants?
Under the 2022 Food Code, TCS food must be held at 41°F or below or at 135°F or above, so the range in between is the zone to avoid[1]. Some local codes use slightly different numbers, such as 140°F for hot holding in New York City[3].
How long can food sit out at a restaurant?
Only as long as your written time-control procedure allows: up to 4 hours, or up to 6 hours for cold food that never exceeds 70°F, after which it must be used or discarded[1].
How often should holding temperatures be checked?
The Food Code does not set a single interval. A practical routine is cold units at opening, mid-shift and closing, and hot holding at least every two hours, with corrective actions logged.
Can I put time-controlled food back in the fridge?
No. Once food is under time as a public health control, it must be used or discarded by the marked time.
References
US Food and Drug Administration (2022). FDA Food Code 2022 (opens in a new tab) ↑
Centers for Disease Control and Prevention (2026). Food Cooling (opens in a new tab) ↑
NYC Department of Health and Mental Hygiene (2025). Rules of the City of New York, Title 24, Chapter 23: Food Service Establishment Inspection Procedures (opens in a new tab) ↑
US Food and Drug Administration (2026). FDA Food Code (opens in a new tab) ↑