Key takeaways
- Cooked TCS food must cool from 135°F to 70°F within 2 hours and to 41°F within 6 hours in total under the 2022 Food Code[1].
- CDC counted 504 restaurant outbreaks over ten years caused by hot food cooled too slowly[2].
- Four in ten restaurants in CDC research cooled food in containers deeper than 3 inches[2].
- Shallow pans, ice baths, ice wands, smaller portions and loose covering do most of the work; a two-checkpoint log proves it.
Why cooling is the step that causes outbreaks
Cooking gets most of the attention in kitchen training, but cooling is where many restaurant outbreaks begin. CDC data covering 1998 to 2008 show 504 outbreaks of foodborne illness in restaurants caused by hot food that was cooled too slowly[2]. The pattern is easy to picture: a large pot of stock, beans or rice goes into the walk-in at the end of the night, the center stays warm for hours, and bacteria that survived cooking, or whose spores did, multiply in the warm middle.
Big batches are the problem. A full stockpot has a lot of heat and very little surface area to lose it through, and a walk-in is designed to keep cold food cold, not to pull heat out of a 20-quart pot. Cooling has to be planned, not left to the refrigerator.
The rule, stage by stage
The 2022 FDA Food Code sets two limits for cooked time/temperature control for safety food. It must cool from 135°F to 70°F within 2 hours, and from 135°F to 41°F or below within a total of 6 hours[1]. Food made from ingredients at room temperature, such as tuna salad from canned tuna or reconstituted foods, must reach 41°F within 4 hours[1].
Stage one: 135°F to 70°F in 2 hours
This is the hard stage and the one that matters most, because food passes through the temperatures at which bacteria grow fastest. If food has not reached 70°F at the 2-hour mark, the cooling has failed.
Stage two: 70°F to 41°F by hour 6
Food has up to 6 hours in total from 135°F, so if stage one took 90 minutes, stage two has the remaining four and a half hours. The refrigerator usually handles this stage if food is in shallow, uncovered or loosely covered pans.
Room-temperature ingredients: 41°F in 4 hours
Cold salads and other foods made from ambient ingredients do not get a two-stage window. They must be at 41°F or below within 4 hours of preparation.
Local codes can be stricter. New York City's inspection rules, for example, measure cooling from 140°F to 70°F within 2 hours and then to 41°F within 4 additional hours[3]. Check the numbers your inspector uses and write them on your cooling log.
Where kitchens go wrong
CDC field research on restaurant cooling practices found the same problems again and again[2]. Four in ten restaurants put hot food into containers deeper than 3 inches. One in four did not loosely cover food while it cooled, which either trapped heat under a tight lid or left the food open to contamination. And one in seven stored food in refrigerators running above 41°F.
None of these require new equipment to fix. They require a rule about pan depth, a rule about covering, and someone who checks the walk-in temperature with a probe in a product, not just by reading the dial on the door.
Cooling methods that work
The Food Code lists approved cooling methods: shallow pans, separating food into smaller or thinner portions, rapid cooling equipment, stirring in a container set in an ice-water bath, containers that help heat transfer, adding ice as an ingredient, and other effective methods[1]. It also requires cooling containers to be arranged for maximum heat transfer and to be loosely covered, or uncovered if protected from overhead contamination[1]. In practice, combine two or three methods for anything large.
| Food | Best methods | Watch for |
|---|---|---|
| Stocks, soups, sauces | Ice-water bath with stirring, ice wands, then shallow pans in the walk-in | Never put a full stockpot straight into the walk-in |
| Rice, grains, pasta | Spread thin on sheet trays or in shallow pans; uncovered in the walk-in until cool | Clumps of rice hold heat in the center |
| Beans, chili, braises | Divide into shallow pans; ice bath first; stir to release heat | Thick foods cool slowly; check the center |
| Large roasts and turkey | Slice or portion before cooling; spread on racks | A whole roast cools from the outside in |
| Batch-cooked vegetables | Shock in ice water if the recipe allows, drain and spread thin | Pooled water insulates the food |
| Concentrated bases | Add ice as an ingredient in place of part of the water | Weigh the ice so the recipe stays right |
- Keep cooling pans no deeper than about 2 to 3 inches of food, in line with CDC's finding that deeper containers were a common failure[2].
- Metal pans release heat faster than plastic tubs.
- Leave space between pans in the walk-in so cold air can move, and keep them off the floor and away from the door.
- Stir with a sanitized utensil every 15 to 20 minutes during the ice-bath stage.
- If you cool large batches daily, a blast chiller pays for itself in avoided waste and inspection points.
Do you need a blast chiller? Decision criteria
Ice baths and shallow pans work for most independent restaurants. A blast chiller is worth pricing when cooling becomes a daily bottleneck. Use these questions to decide.
- How many large batches do you cool on a typical day? If the answer is more than two or three, ice baths start to tie up a sink and a cook for much of the afternoon.
- Do your cooling logs show stage-one readings close to the limit, or corrective actions more than occasionally? Repeated near-misses mean your current methods have no margin.
- Is walk-in space the constraint? Speed racks of shallow pans take room that a blast chiller frees up.
- Do you batch-cook for several days or for catering? Larger, less frequent batches make faster cooling more valuable.
- Is the walk-in struggling? If adding warm pans pushes stored food above 41°F, the walk-in is doing a job it was not designed for.
If you answer yes to two or more, get quotes and ask suppliers for the unit's rated pull-down time for a full load. If you answer no to all of them, invest instead in more shallow metal pans, two or three ice wands and a clear cooling schedule. Either way, keep logging both checkpoints: equipment speeds cooling up, but only the log shows that it worked.
Example: cooling a 20-quart batch of chili
Example: a fictional diner makes 20 quarts of chili on Monday afternoon for the week. The old routine was to cover the pot and put it in the walk-in at close. A probe check the next morning found the center at 58°F after more than 12 hours, so the batch had to be thrown away.
The new routine in this example: at 3:00 p.m. the cook moves the chili from the stove to a sink filled with ice water and stirs with an ice wand. At 3:40 p.m. the chili reads 110°F and is portioned into six shallow hotel pans, each with about 2 inches of chili, set uncovered on a speed rack in the walk-in. At 4:50 p.m., one hour and fifty minutes after the start, the warmest pan reads 68°F. Stage one passes. At 7:30 p.m. the pans read 40°F, well inside the 6-hour window, and are covered and labeled. The cook logs all three readings.
A cooling log your cooks will use
The log needs to answer three questions: what was cooled, when did it start, and did it hit both checkpoints. Keep it on a clipboard next to the walk-in door, not in the office.
| Field | What to write | Why it matters |
|---|---|---|
| Item and batch size | Chili, 20 qt | Big batches need more methods |
| Start time and temperature | 3:00 p.m., 180°F | The clock starts when food drops below 135°F, so note the time it passed that point |
| Method used | Ice bath, ice wand, six 2-inch pans | Lets you compare methods over time |
| 2-hour check | 4:50 p.m., 68°F | Must be 70°F or below to pass stage one |
| 6-hour check | 7:30 p.m., 40°F | Must be 41°F or below by the total time limit |
| Corrective action | None needed, or what was done | Shows the system works when a check fails |
| Initials | Cook and manager | Accountability for each batch |
When a check fails, follow the corrective action your local code allows, which commonly means reheating and restarting the cooling within the time limits, or discarding the food. Write down what you did. A failed check with a correction shows control; a log that is always perfect, filled in at the end of the night in the same pen, shows the opposite.
Make it part of the prep plan
Most cooling failures start with timing: a big batch cooked too late in the day for anyone to manage it before close. Build cooling into the prep schedule.
- Schedule big-batch cooking early in the day, when there are hands free to cool it.
- Assign a named person to each batch from the moment it comes off the heat.
- Set phone or kitchen timers for the 2-hour and 6-hour checks.
- Make smaller batches more often if you cannot cool large ones in time.
- Hand over any open cooling log at shift change, out loud, with the next check time.
Cooling sits inside a wider temperature routine described in temperature danger zone and time controls, and once food is cooled it needs a date label, covered in date marking and FIFO in restaurants. If you cool vacuum-packed food or cook sous vide, check HACCP plans: when restaurants need one, because those processes have their own rules. FDA has published a 2026 Food Code edition[4]; ask your health department which edition and cooling limits it enforces.
Frequently asked questions
What is the two-stage cooling rule?
Cooked TCS food must cool from 135°F to 70°F within 2 hours, and to 41°F or below within 6 hours in total, under the 2022 FDA Food Code[1]. Some local codes start from 140°F[3].
Can I put hot food straight in the walk-in?
You can put shallow pans of hot food in the walk-in, but not a full stockpot or deep tub. Large batches need an ice bath, ice wand or portioning first, or they will not meet the 2-hour limit.
Should food be covered while it cools?
Loosely covered, or uncovered if it is protected from overhead contamination, so heat can escape[1]. Cover tightly once it reaches 41°F.
What if food misses the 2-hour checkpoint?
Follow your local code's corrective action, commonly reheating and restarting the cooling or discarding the food, and record what you did on the log.
References
US Food and Drug Administration (2022). FDA Food Code 2022 (opens in a new tab) ↑
Centers for Disease Control and Prevention (2026). Food Cooling (opens in a new tab) ↑
NYC Department of Health and Mental Hygiene (2025). Rules of the City of New York, Title 24, Chapter 23: Food Service Establishment Inspection Procedures (opens in a new tab) ↑
US Food and Drug Administration (2026). FDA Food Code (opens in a new tab) ↑